|
#1
|
||||
|
||||
Quote:
Can't you drill out the corroded screw and then replace with a new stainless steel screw? I've seen this done on 121 bars before! Hope that helps! I am about to do the same.
__________________
"I LOVE the smell of WIND in the morning... Smells like..... KITING!!" "The biggest drawback of kiteboarding is the adverse effects it has on getting anything else done." |
#2
|
||||
|
||||
That is what I am about to try before I go down the epoxy route. The problem I see is that I can only access the screw from the top so I am not sure how I am going to "drill out" the scew without damaging the thread.
What are you thinking of doing to get around this???
__________________
Felipe |
|
|