|
#1
|
||||
|
||||
you dont have to remove the bladder to change the valve.....
__________________
handle passes are easy... at least i think they were.. been so long i cant remember |
#2
|
|||
|
|||
Before you do that, clean out that dump/inflate valve real well.
Where you screw it in, sometimes small bits of sand get in there and cause the seal to leak, slowly. That might save you a major headache if that's the actual problem. BigR, does that kite have that valve? I am assuming. |
#3
|
||||
|
||||
Yes the contra has a screw in dump inflate valve that constantly gets sand in it.
I always clean mine religiously just B 4 inflating the kite each session. If its the valve and NOT the bladder then clean it out, problem solved
__________________
__________________ ___________________________________ You don't direct ostriches, you herd them |
#4
|
|||
|
|||
big valve seems to be leaking slowly cleaned valve and still leaking slowly where you screw the valve together. what should i do to seal the valve better, silicon or something like that.
|
#5
|
||||
|
||||
Try to make a determination if it is the valve itself OR if it the valve seal to the bladder which is leaking.
I would not use silicon or oil just water to seal the valve itself as the solvents in these hydrocarbon based mixtures might do more harm than good.
__________________
__________________ ___________________________________ You don't direct ostriches, you herd them |
#6
|
||||
|
||||
try some thread tape.. see if that helps..
|
#7
|
||||
|
||||
If you come to the conclusion that it is the valve itself and not the valve to bladder seal then you can easily replace it with a new one by just pulling the o ring out from around its groove and getting a new valve
__________________
__________________ ___________________________________ You don't direct ostriches, you herd them |
|
|